Skip to main content

Sub Gram Ornithopter

I can't help myself. Every time I build something I invariably think of ways I can build it smaller. I built a large ornithopter, now I have to build a small one.


This ornithopter comes in at 920mg, just under 1g, and has a 2.5" wing span. It has 4 flapping wings. The two wings on each side flap towards each other and then away from each other. This produces both thrust and lift. 


It is powered by a 8.5mAh single cell lithium polymer battery. Flight times are around 3 minutes per charge. Controls are done through an infrared receiver system which can command the throttle and rudder. The rudder is actuated with a small magnetic actuator.

The motor is a single phase brushless design that is geared 10:1 to flap the wings. The frame is all carbon fiber rod between 0.01" (0.25mm) to 0.02" (0.5mm) in diameter. The covering on the tail is OS Film while the cover on the wings is some thin grocery bag plastic film.


This is very weird to watch fly. The wings are a blur and the whole vehicle looks like its being propelled by a large dust ball. It flies quite slow and looks very much like a large insect. I wouldn't dare fly this outside.. I'm positive a bird would make a meal out of it.



Other People Thought These Were Cool..

Micro Servos

When I started to take a break from microscopic flying vehicles in 2010 and migrate towards some larger, easier to work with, models (5-20g) I realized that magnetic actuators just weren't going to cut it for control (rudder, elevator, ailerons). Magnetic actuators are heavy and draw power continuously when deflected away from neutral. I needed servos. Servos would provide lots of pulling force for their weight but at the cost of mechanical complexity. Since servos at the weight I needed didn't exist or were out of my price range I decided to further over complicate the situation and build my own. I started by designing a simple linear servo (lead screw design). The picture above is of my 400mg variant which has a throw of about 0.2", resolution of 0.0015", and can pull about a 25g load. The motor is a brushed 3.2mm diameter coreless design by Shicoh. The gears used are module 0.15 and can be gotten from http://www.kkpmo.com/ . The threaded rod is 0000-160, which

3D Printed Mechanical Pencil

What better way is there to spend multiple consecutive weekends than sitting at your computer, redesigning a mechanism that has existed for decades, all to be able to 3D print something that can be bought at the store for less than $1? ... That's right, anything. However, when your co-worker throws down the gauntlet there is only one thing to do. Take it up.

Nerf Desolator Mods & Upgrades

Ever since I was a kid, I enjoyed playing with Nerf guns blasters. I just liked shooting things around the house, which included my brother. I remember shooting suction cup darts at our CRT TV while watching shows (aiming at the characters / actors). It was way too much fun.